NERCR - Slippy floor and carpet, one large jump plus some rippled mats
Front
- Blue Spring
- Additional 57 hole in piston
- Oil 35wt
- ball joint done up on shock just showing thread
- push rod turnbuckle - 34mm - mounted on top of rocker
- top wishbone fully back except for two small washers
- ride height - slightly lower than the back
- max droop
- Roll bar in long link (rear hole in wishbone)
- camber 1 deg
- Slight toe out
- Standard wing
Rear
- Blue spring with compensator spring
- middle hole on wishbone (thats with the longer shaft, may need lower hole)
- Additional 57 hole in piston (standard one is about 57 also)
- 30wt oil depending on temp
- Lower hole on the hub [high position]
- Roll bar in short link (rear hole in wishbone)
- wing forward half gurney
- toe-in 3 degs
- 1 deg camber
- ride height - wishbone level
- max droop
Extras
- Motor LRP x11 bonded 6.5
- One-way shaft - three o-rings on brake bias
- Bumper cut down to improve ground clearance on landing jumps - see picture
- Cone washers on top of front hubs removed and replaced with two 1mm washers underneath the wishbone and 1 on top.
- Rear anti-roll bar lowered
- Schumacher Mini-pins - yellow compound with blue foams/inserts
- Cut the inner two rings off the surface of the rims (see picture)
I think i've remembered everything there