here is a starting point for the new shocks on the x11 working both on flat grass and epr as well
front
springs blue (no compreision spring) 5 1/2 turn in older style
oil 25wt losi
piston kit with standard rebound valve
pushrod above rocker
pushrod lenth 33mm with shockball undone 1turn
revised front arms with 1 washer behind wishbone
cone washer replaced with 4 losi gold ballstud washers. 2 under outer ball with 2 above
extra midde hole drilled for roll bar
roll bar 1.2mm (standard) middle hole
ride height 19-20 mm
front wing kit with standard lines followed
slight toe out with 2 degrees of camber
rear
springs blue (no compresion spring) 5 1/2 turn in older style
oil 30-32.5 losi(depending on jumps)
piston kit
lower hole on shock mount
roll bar 1.2mm again in middle hole in lowered position (pic to follow)
wheelbase lenthened 1mm
ride height 22mm
1.5mm rear block (reduces on power steering)
large rear wing with full guerney
toe in to middle of front wheel
rear uprite in upper hole
shumacher yellow minispikes with outside outer row cutoff rear and 2 inner and outer cut off front
any extra info you need feel free to ask or pm
Nathan
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams
woop woop racing officialy keeping team toe out inline
Last edited by niggs98; 12-06-2008 at 08:48 AM.
Reason: to keep everyone happy about the bits i missed lmao
|