So boltted the front end tonight.
Main reason for getting this on was to try and "approximate" the wheelbase.
have to factor abit of human error too.
stuck a dummy rear axle in (which was measured from the out side i might add not the centre) and the front was close as accurate quess witha tape measure.
i calculate it at 293mm if i was to half the rear axle prob be more like 291.5mm even 290.
this is better than i thought considering the wheel bases of below.
AE B6 - 280mm
TLR 22 3.0 - 280mm
PRS1 v3 - 285mm
Kyosho Rb 6.6 - 285mm
Kyosho RZ6 -295mm
So not million miles away. this was also measure with the rear blocks at there outter most position so there is scope to bring it in shorter as also i have seen a feont mod where it allows you to make the have a forward and reward position which are on a rather good rc website...
Could i think bring it right down to the 280mm mark just by sliding the gearbox/shocl tower block rearwards more and re jigging/tightening up the waterfall brace.
LLL
__________________
_____________________________________________
Kyosho TF2 Kyosho TF3 Kyosho TF4-R
Kyosho Lazer ZX-R Mk2 Kyosho ZXR Kyosho zx
Kyosho Lazer 2000 (with zx parts)
Atomic CR2 SCT
_______________________________________________
Trader Feedback thread