Found a little time to modify some Scorpion re re rear axles to make front axles , these will hold the roller hub on with a regular nut rather than a C clip , i had to first anneal them then turn them and finally harden them again , i also had to insert a 6mm drill bit shaft into the cup so i could hold them in the lath chuck without squashing them but it all worked out and with only slightly frazzled nerves :shock:
Shown with an original thats much lighter in colour .
Next will be to turn and mill the square drives for fron and back , I've got the one way bearings for the front and I'm expecting the little flanged bearings that go either side to arrive tomorrow .