View Single Post
  #3  
Old 17-06-2009
superdez superdez is offline
Member
 
Join Date: Dec 2008
Posts: 174
Default

Altough i have never run an RC 10, I do have experiance of the associated shocks as i have just restored a Yokomo Works, and have used associated shocks all round, and after reading numerous posts on RC 10 Talk i am pretty sure you will need the following itmes.

.56 or .71 shocks on the front with the applicable shafts.

1.02 or 1.32 shocks on the rear. the 1.32 will require a spacer inside the shocks, again with applicable shafts.

The rears are available from tower hobbies in the states as whole kits as are the .56.

They use the same internals as modern associated shocks as well as the caps.

You can get the .71 bodies from CML still.

VALKYRIE RC MOTORSPORTS on ebay usually as good second hand/vintage rc 10 stuff

Hope that helps
Reply With Quote