The Durango importer may only consider a replacement if you return all the parts to examine and something is machined wrong.
I hard to see that all parts that you have purchased are machined wrong, but could be. But from the info from the last few messages it looks like the driveshaft has not been pushed on far enough. As the instruction says 2.8mm is the correct spacing. At 3mm you should of been asking the shop where you purchase the car about the measurement being wrong and why. This is why a shop makes money from us.
A question for Adam:
In the instruction it a cross next to the 2.00mm setting. No way could I ever get a 2mm setting if I tried. Should it read 3.00mm? That would make more sense and may stop this problem from happening again.
|