Quote:
Originally Posted by sly
From Standard mine has losi front hex bolts to hold the wheels on, Losi 22 drive shafts as the kit ones have had some failures and the losi driveshaft are a straight swap, crush tubes, i made mine from old 4x5x10 bearings and broke them down to use the center from them.
I built mine wrong from day 1 regarding the rear wishbones direction, and the drive shafts and wishbones are straigher coming from the gearbox and when i notice and tried it the correct way i found it miles better the wrong way.
Grub screw the rear hinge pin in the hub.
I used a 8mm drill bit to drill by hand some of the center of the diff case to allow a shock o ring to be a better seal.
May layout has only ever been shorty and i have not found the need for changing it.
 |
How does the rear wish bone flipping make the car drive? I'm interested in doing this, but was worried it would make the car too long?