Hi Culetto
Sorry I do not get on here much recently.
I am glad you love your darc
And what a shame that screw came loose
We are completely out of clutch adapters and sadly cannot find a new supplier to make them.
So then
What to do?
How are your engineering/ modding skills
What I would advise
Is to take some 2mm Durango drive shaft pins
Drill with a 2mm drill bit into the broken adapter where the ears/lobes were to a depth of 8mm
Insert the drive pin (10mm length) so you should then have 2mm of pin sticking out
Then bolt on out drive as before with the special darc ( white dotted ) screw.
The beauty of doing this mod is that you can replace the pins
This is how our prototypes were driven and tested.
Hope this helps
I will post a pic from the prototype
Thanks
Scott
|