Well last night i went to club to see the top kyosho guys there and thought my zx was ready but couldnt find enough power and on the infield in certain areas i was quicker but turned out my rear belt snapped again so today ive cut away a section on the gearbox where the third screw thats the lowest of the three holding the gearbox to the motor plate. Ive added a bearing (same size that holds the diffs in place, thats pushing in the belt to make it taught. I did try the zxs belt tensioners from the rear gearbox but couldnt get it right. The only problem i have now is the smallest pinion i can use is a 22 as the bearing just misses my 6.5 but will do until my design is done. Pics to follow.
|