Quote:
Originally Posted by Essexboyracer
If you test with another multimeter and they say no voltage, then the're dead. If however they read say 5v or higher, you may be able to revive them.
I had a pack which dipped too low for a normal lipo charge, but I read that a couple of minutes on a NIMH charge could get their voltage back enough for a regular charge. I did that, and after their voltage had picked up a bit, I then did a normal LIPO balance charge. That pack worked fine afterwards. Care must be taken with this process, as if they get left on NIMH charge for a full charge, it would likely not go well.
So if they are only a bit low, feel free to try this advice. You can probably find a more detailed guide somewhere on the web.
EDIT: I think I followed the MaxAmps guys advice on this thread.
http://www.rctech.net/forum/maxamps-...w-voltage.html |
Hi Guys thanks for the info,
I did that trick with the nimh charge and i got the lipos up over 6v and i was able to change again and they are reading full power now i did a few runs and they seem ok
See you soon
Eoin