Quote:
Originally Posted by Martin.s
When I plug the speedo into the battery and turn it on, the red light comes on as expected. I then hold the power button and the speedo goes into calibration mode (the red light flashes and the motor beeps as it should). This should calibrate neutral. I then press the speedo button to signal the neutral point and the speedo turns off rather than recognising neutral. I then cannot get the speedo to turn on again unless I unplug the battery. The speedo then turns back on, but when I try to enter calibration mode the same thing happens.
|
May sound silly, but when you say it turns off, are you sure it isn't just that the light has gone out because you've set neutral and it's waiting for you to go to full throttle and press the button again?