cant get set up sheets to upload to oople...files too big and i dont know how to alter them so ill just write them out..
centro rear
no.1 piston,30wt oil green spring and one .030 limiter
2nd hole from inside on shock tower
inside on wishbone.
camber link inside and top hole on shock tower
middle hole on plastic hubs
2 degree anti squat
medium wheelbase
yellow minispikes outer and inner row spikes cut off..sch med foams
ride height 20mm
centro front
no.2 piston,40wt oil,silver spring,two .030 limiters
inside on shock tower
outside on wishbone
camber link inside on tower,1 washer
inside on hub
30degree caster blocks.
fastrax front brass bulkhead.no further weight on this..
rudebits brass under steering rack weight.
20g in front of servo..
yellow cut stagger sch tyres sch med foams
ride height :wishbones just below level
b44.1 front
no. 2 piston,37.5wt oil,silver spring,one .030 limiter
shocks: inside on tower
outside on wishbone
camber link inside with one washer on ball stud
link outside on hub
ride height-just below drive shaft level
ackerman in the back position
sch minispikes yellow,outside and inside rows cut off sch med foams
rear
no2 piston,25wt oil,green spring,one .030 limiter
shocks:inner hole on tower,
inner hole on wishbone
camber link
utside on bulkhead,one washer
2nd from inside on hub block A
silver roll bar
one washer on anti squat plate.
medium wheelbase
60g rudebits brass centre weights
hope this helps...contact me if any more info needed.