not sure if they'll load. and i have more recent higher res. pics if you want. after the design is finalised, i'm going to use a new chassis. not wanting to mess up a 40.00 chassis. i used the b44 steering and front center cv drive. going to use NTC3 single speed. adapted the ae .15 engine for non-pull start. b44 center bulkhead and tamiya 31mm dogbone to couple slipper shaft to output shaft in the rear. (no slipper) b44 diff cases front and rear.
(Edit: these are recent, and i have elecs. installed now, just need more hardware and new shocks. aslo i chose to make a combo dogbone/CV center drive that is not done in the pictures.)
|