Thread: Lazer zxr
View Single Post
  #5850  
Old 08-11-2018
Ubiquitous Ubiquitous is offline
Member
 
Join Date: Dec 2017
Posts: 39
Default

Quote:
Originally Posted by Welshy40 View Post
Big time as the belt will snap / shred if you dont. Set it so its a fractional slip from start. Don't over do it as you'll ruin the slipper pads. Picture quality wasn't spectacular so wasn't sure if it was a vts but the spur did look smaller, but be warned may cause issues to the motor due to a bigger ratio. Still game on and have fun.

Welshy,

A spur gear with 93 teeth is only 7% smaller than the stock one. Can this not simply be compensated by going down 1-2 teeth on the pinion, with the benefit of having a reduced rotating mass?

Ubi
Reply With Quote