[xfactor]

So since the original build, I have a few little updates.

1. I have replaced the plastic ballstud mount on the Rear, for the alloy upgrade.

2. I have fitted the original TRF201 rear-front hinge pin mount. The only difference from the TRF201 XMW rear-front mount is its machined at the front to allow the motor further back in mid-motor. But with the YZ2 gear box I can now fit the TRF201 rear-front mounts allowing 3.0-5.0 rear toe in, with the extra toe from the TRF alloy rear hubs.....

3. I have changed the Water Fall from the Worlds to the Original Water Fall. This is yet to be tested, but I want to see what the difference is, if any....

4. I went to COBRA Racing again. I wanted a small alloy machined block for the back rear. Not that it is/was needed, it was just for peace of mind really, as now the alloy block sits on top of the hinge pin holder. Perfect fit !!


Pictures showing all the above..... CLICK TO ENLARGE...