Here is the setup i finished up on at Worksop.
Front -
Track Washers - 1mm front and back
Roll Bar - No
Shock Position Mount - Middle
Shock Position Wishbone - Middle
Front Rake - 10 Degrees
Washers - 3mm
Front Link Bracket - 43mm
Washers on Hub - 0
Rear -
Wheel Base - Short
Toe In - 3mm Rear, .5mm front = 3.25 degrees
Anti Squat Washers - 2mm Rear, 1mm Front = 1.3 degrees
Rear Link Bracket - 37.5mm
Washers - 4mm
Shock Position Mount - Middle
Shock Position Wishbone - Inside
Hub Postion - Middle
Roll Bar - No
Shocks
Front -
30wt on 3 Holes
Schumacher Red Springs (Old)
Diaphragm - Centre cut out and removed
Ride Height – Drive shafts level
Rear -
25wt on 3 Holes
Schumacher Yellow Springs (New)
Diaphragm - Centre cut out and removed
Ride Height – Drive shafts level.
Transmission-
Rear Diff Height - Low
Front Diff Height - Low
Layshaft Pulley - Pin Through
Front Drive – One Way
Gearing - 83 x 24 on Speed Passion 5.5
Internal Ratio - 36 Tooth Pulley
Thanks
Si
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC
|