|
#41
|
||||
|
||||
|
#42
|
|||
|
|||
Gaz, I used the standard motor cover, drilled and tap the Vega motor plate for the hole at the back and use a long screw at the front cover hole, which would clamp to the heat sink. I then made a motor plate out of old lexen, which sits against the Vega MP. Was quite fiddly but work for the five mins a ran it.
The standard motor plate will not fit behind the slipper plate unlike the Vega RB5 which does fit. Have a look at Lee's car, this is what I did.
__________________
http://insidelineracing.co.uk |
#43
|
|||
|
|||
Quote:
I'm trying both cars back to back What 4wd now then? Gaz
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
#44
|
||||
|
||||
Does anyone still have one of these cars ?
__________________
Associates B6.1 - Reedy |
#45
|
|||
|
|||
I still have a Vega! Pretty much just a shelf queen though
__________________
Team Losi Racing, Horizon Hobby TLR 22 5.0, TLR 22X-4, TLR 22-4, 22-4 2.0 Atomic Carbon S2, S44, Vega B4.1 Trader feedback: http://www.oople.com/forums/showthread.php?t=19374 |
|
|