|
#41
|
||||
|
||||
Thanks for the explanations. I will try it soon on my club track (astro, tight layout).
Can I call you Super ? C U in Belgium ! Cheers, Raphael |
#42
|
|||
|
|||
Hi Dan,
Any possibility to get a picture of the X6 rear camber link flipped low? Thanks |
#43
|
||||
|
||||
x5 and x6 junoirs set ups from silverstone
======
__________________
Mattys the driver,my names carl
|
#44
|
||||
|
||||
Quote:
|
#45
|
||||
|
||||
lol so true lee, i seen smoother farmers fields lol
__________________
Mattys the driver,my names carl
|
#46
|
||||
|
||||
+++++
__________________
Mattys the driver,my names carl
|
#47
|
||||
|
||||
I know Chris is getting an X5, is he considering an X6 too?
__________________
Nortech is ACE! |
#48
|
||||
|
||||
Chris was super happy with the way the x6 went, i think he will have one before long.
Here is my setup as promised: Front: Silver springs, 35wt ae oil ,losi red piston. 2spacers internal. camber link inside on hub and shocktower mounting position. -1 deg camber 0 deg toe in/out 30 deg caster blocks shock pos. middle hole on tower inside on wishbone outer row of spikes off front tyres Rear: silver spring 30wt ae oil, losi red piston. camber link outer hole inboard and outside on the hub 0 deg anti squat (2 thick spacers) .009 shims under gearbox shock pos. 2nd hole from inside on tower middle on wishbone. short wheelbase on hub and wishbone -1 deg camber wing forward as far as possible no extra weight added. Lee |
#49
|
||||
|
||||
+++++
__________________
Mattys the driver,my names carl
|
#50
|
|||
|
|||
Has anyone got a good X-5 set up for Coventry's astro?
Bit short notice I know...
__________________
Quote:
pm me bitch, or is it past your bedtime?
|
#51
|
||||
|
||||
dom use the same set up as your xx4 shut your eyes and hope for the best
__________________
Cobra Racing Products,Penguin Custom Bodyshells,Ultimate RC Workshop,RC Car Zone |
#52
|
|||
|
|||
Help Required
HI
I am looking for some advise on what gearing to run my x5 squared on for this weekend at our first regional and also the first time with this car in anger as so far I have only been able to is make sure it works I'm running a 10x2 peak vantage motor with a Novak GTX speedo The car has got a 104 tooth spur. The track is astroturf and is being held at the Eastracks if this helps. Many thanks in advance. |
#53
|
||||
|
||||
start around 18 and go up to 21-22 may be depending on the track keep a eye on the heat of the speedo
__________________
Mattys the driver,my names carl
|
#54
|
||||
|
||||
Actually when I ran brushed I was rarely on anything higher than a 17-18. Defo start at the bottom end of the range and work up.
__________________
Nortech is ACE! |
#55
|
||||
|
||||
Vaasa, Finland (last Euros)
Ellis, could you be so kind as to post your setups for the X-6 and X-5 from this track?
We have the Nordic Championship there in june...
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#56
|
|||
|
|||
Here you go Shy, but my set ups are way different now as I have learnt a lot more about the cars since.
I have put them in but also how I have been running the cars recently that to be honest I would be tempted to try first if I was to go there again. E. |
#57
|
||||
|
||||
My bad! Delete!
|
#58
|
||||
|
||||
Ellis, thank you so much for your help!
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#59
|
|||
|
|||
No problems
|
#60
|
||||
|
||||
Ellis, was this the tires allowed also for the EC?
2WD Modified Rear:
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
|
|