|
#1
|
|||
|
|||
To mark penney
Can you post your setup used this week-end for your C4.1 and B44.1?
Great thanks for answer |
#2
|
||||
|
||||
pm him, noreargrip is his user name.
__________________
Team Schumacher www.racing-cars.com Paint by www.customblitz.co.uk Feedback http://www.oople.com/forums/showthread.php?t=67178 |
#3
|
||||
|
||||
I sure can...I'll write up the set ups and attempt to put them on tomorrow night...
|
#4
|
||||
|
||||
set ups
cant get set up sheets to upload to oople...files too big and i dont know how to alter them so ill just write them out..
centro rear no.1 piston,30wt oil green spring and one .030 limiter 2nd hole from inside on shock tower inside on wishbone. camber link inside and top hole on shock tower middle hole on plastic hubs 2 degree anti squat medium wheelbase yellow minispikes outer and inner row spikes cut off..sch med foams ride height 20mm centro front no.2 piston,40wt oil,silver spring,two .030 limiters inside on shock tower outside on wishbone camber link inside on tower,1 washer inside on hub 30degree caster blocks. fastrax front brass bulkhead.no further weight on this.. rudebits brass under steering rack weight. 20g in front of servo.. yellow cut stagger sch tyres sch med foams ride height :wishbones just below level b44.1 front no. 2 piston,37.5wt oil,silver spring,one .030 limiter shocks: inside on tower outside on wishbone camber link inside with one washer on ball stud link outside on hub ride height-just below drive shaft level ackerman in the back position sch minispikes yellow,outside and inside rows cut off sch med foams rear no2 piston,25wt oil,green spring,one .030 limiter shocks:inner hole on tower, inner hole on wishbone camber linkutside on bulkhead,one washer 2nd from inside on hub block A silver roll bar one washer on anti squat plate. medium wheelbase 60g rudebits brass centre weights hope this helps...contact me if any more info needed. |
#5
|
|||
|
|||
big thank you to Mark for answering. It's very nice and very fast too.
|
|
|