Losi Springs...

[Crazychambers]

Hi all,

Just looking through the setups on HB europe, and for the Schumacher indoor series I see Adam Skelding is running with Green front and Red rear Losi springs.

Just wondering if anyone can coment on what difference these make to the car in comparison to the kit springs?

Also, does anyone know the part number for these?

Thanks for the help

Dan

[blitzboy]

hi mate i ran them on my d4 when i had one and rto me it was far better speak to darren at dms racing mate he will know the part numbers anyway and will probably have them in too

[Darren Boyle]

A5132 green front
A5152 red rear

did not want to disappoint you Graham

[mark christopher]

also use silver front and pink rear

[Adam Skelding]

Originally Posted by Crazychambers

Hi all,

Just looking through the setups on HB europe, and for the Schumacher indoor series I see Adam Skelding is running with Green front and Red rear Losi springs.

Just wondering if anyone can coment on what difference these make to the car in comparison to the kit springs?

Also, does anyone know the part number for these?

Thanks for the help

Dan

Hi Dan,

I just found the HB springs were a little to soft for the tracks we have over here and also a little long. They tend to get 'coil bound' on full travel which effectively negates the spring and loses you grip, usually on the rear.
The springs I have on my car are HB prototypes which are similar to the Losi ones.

It also made it easier for me to understand the car as I ran XX4 and XXX4 for around 10 years. It's easier to start with something you know. You need to use the short spring perch with the losi springs. The Taller spring perch is for if you use AE springs.

[Crazychambers]

Adam,

Thanks for that. Are the spring perchs' for the losi spring the same as the ones used for the HB springs or do I need to get hold of some others?

Thanks

Dan

[Adam Skelding]

Nope, you don't need to get hold of any others.
They're the ones from the HB kit.

[Crazychambers]

Originally Posted by Adam Skelding

Nope, you don't need to get hold of any others.
They're the ones from the HB kit.

Thanks Adam, I'll get hold of some and hopefully give them a go at Broxtowe. Also see on your setup sheets you run a -1.5mm rear roll centre, just a question of how you acheive that!!

Thanks for all the help

Dan

[Adam Skelding]

The roll centre can be acheived with a dremel.
But I've been using some prototype carbon plates. They've been showcased on oOple before.

They'll be available from December..

Keep an eye on www.hbeurope.com and mirageracing.com for their release.