|
#1
|
||||
|
||||
cougar front shock limiters
Hi,
Iv noticed on some of the setups it says 2mm front shock limiters,what do they do(dont state the obvious)and when would you need to use them, thanks |
#2
|
|||
|
|||
I normally use limiters when using Stagger ribs to ensure that the droop/uptravel are still correct, as it is a smaller diameter tire.
I try to ensure that the front always as slightly less droop & uptravel when compared to the rear.
__________________
Yokomo - LMR |
#3
|
||||
|
||||
i run the lower front shock as i run with stagger`s,i thought it was for when you used them,but it give more up travel than the rear and not much less on the downtravel,iv got mt rear ball cups undone 3 turns,
am i just better off putting the old shock tower back on? |
#4
|
||||
|
||||
whats the part number for the 2mm front limiters??
|
#5
|
||||
|
||||
Mark, I'm getting worried about the number of technical set-up threads you're creating recently. Are you taking this seriously now or something?
__________________
Current Weapons: YZ2-CA, YZ2-DT, YZ-4SF. In The Pits: Yokomo R12C, Yokomo MR4-TC Custom, Yokomo MR4-TC Pro, Yokomo MR4-Rally, Tamiya Blitzer Beetle, Tamiya M05. Driven: Race Red Fiesta ST
|
#6
|
|||
|
|||
Quote:
I use 2x 0.030" Associated shock limiters, but any 1/8" ID spacer should work.
__________________
Yokomo - LMR |
#7
|
||||
|
||||
thanks Tom
|
#8
|
||||
|
||||
Tom, you're the man! Thank you for being so available on forums...
|
#9
|
||||
|
||||
I second that, thanks Tom!!
|
#10
|
||||
|
||||
He's a good kid
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing |
|
|