!help!

[bmx833]

i was running my week old sphere today in my b4, i couldn't here the noise of the fan so i took the body off to find the fan wires pulled out(out of the fan not the sphere), how do i go about putting them back in because i need the fan for my touring car

any help appreciated

thanks in advance

Brad

[DCM]

the wires have physicaly come out of the fan, or off the Sphere?

[bmx833]

out of the fan

[DCM]

you will need a new fan. the wires can't be put back into the fan, sorry.

[bmx833]

oh, ok, ill get one ordered
thanks for the quick replies

Brad

[Northy]

Originally Posted by DCM

you will need a new fan. the wires can't be put back into the fan, sorry.

I put one back on mine, requires a very small soldering iron tip, a steady hand and to cut a little bit of the fan away

G

[mark christopher]

Originally Posted by Northy

I put one back on mine, requires a very small soldering iron tip, a steady hand and to cut a little bit of the fan away

G

same for me
we must be good or tight asses G!!

[bmx833]

what bit do you solder it onto?

[DCM]

ok, you can solder, but it is mighty fiddly, and if you can't solder well, then you are going to knacker the fan anyways.

[bmx833]

im quite a good solderer i just dont know what way and where to ssolder them on?

Brad

[DCM]

the motor will be the centre portion of the fan, you should be able to trace where the wire goes into.

[bmx833]

[bmx833]

theres a pic

[DCM]

you will need to pull the round label off the back of the fan, and they should be obvious to you then

[bmx833]

i pulled it off and all there was was a littlr hole wite the motor shaft in it