Go Back   oOple.com Forums > General > 12th & 10th On Road

Reply
 
Thread Tools Display Modes
  #1  
Old 09-01-2022
nerius nerius is offline
New Member
 
Join Date: Apr 2007
Posts: 25
Default Specs for rear wheel mount interface

I don't own a 1/12th scale car but am looking for exact specs for the rear wheel 3-bolt mount interface for these 1/12th scale cars (e.g. Eclipse3). I know there's another variant with a 12mm hex (which usually does not have a rear diff I think), but I'm looking for info about the older 3-bolt style wheel mount system.


In particular, the bolt circle diameter (BCD). I think it's 16mm but am not sure. I analyzed the diagram in one of the instruction manuals and came up with 16mm diameter and change.


Also the "offset". From the mount surface plane, what is the distance that the rear wheel "sticks out" by.


Lastly, the center hole diameter. Does the hole in the rear wheel sit snugly and if so what diameter (I would expect around 10.5mm).


I am designing 12th scale drive trains and am having a difficult time finding info on this on the internet.


Also helpful would be information about the front wheel offsets etc. I think rear diameter for tire is approx. 46mm and front is approx 44mm.


In case you are curious here is a video showing some of my work.
https://odysee.com/@Neri_Engineering/4wd-road-diff-assy
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 10:04 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com