|
#1
|
||||
|
||||
Broxtowe setup
Guys,
After a little help with a setup for broxtowe, ran the one below at the weekend but found the car very pointy and seemed to have bad stablity issues with the inside rear wheel unloading.... (running a roll bar did help!) Front: Std front camber plates - no shimming Losi Green Spring 40 Wt AE oil Number 2 Piston Hole 3 on tower Outer hole on arm 10 deg caster -1 camber Rear: Std camber plates - no shims Losi Red Spring 30 Wt AE oil Number 3 piston Hole 2 on tower Outer hole on arm -1 camber 3 deg rear block 0.5 deg hub 2.5mm on hub 0.75mm under rear block Silver sway bar Any advise / a base setup to run would be appreciated. Running a Lipo weighted up to the same as Nimh Thanks in advance! |
#2
|
||||
|
||||
adams set up from broxtowe
http://www.hbeurope.com/pdfs/setups/...m_Skelding.pdf http://www.hbeurope.com/setups.php?partNo=61700&lang=en when was the rear whel unloading?
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#3
|
||||
|
||||
Ur just a girl Dan!!
We ran Adams setup Chris, with a lil tweaks here and there.It tended to lift the wheel on exit,i think it was down to,to much traction myself.Maybe try a longer rear wheelbase next time dan,or something abit more drastic like an oil/spring change! Dunno if my car was better than yours as i ran the edit oil? How diffrent is the edit oil compared to the AE oil? I still wheeled it round for 3rd so carnt have been that bad!
__________________
Team Yokomo | ToniSport | Gav Grafix | MHP |
#4
|
||||
|
||||
Good knows, just think its my bag of tallent running close to empty again!
Looking at it, I was running the Worksop setup from adam, theres a few bits different for his Broxtowe one. Probably be work trying that! Tried giving to big finish in the karts today tho dude, didn't work out so well! |
Thread Tools | |
Display Modes | |
|
|