|
#1
|
|||
|
|||
KF2 Lipo post modification
Hello all,
Just going to try and low profile lipo in my KF2 but just wondering if there is a way that I can modify my original posts so that I can run both low profile and normal lipos. Anyone done anything in the way of this and what are the advantages of using lower lipo Any advice please J |
#2
|
|||
|
|||
I just used some dense foam like this:
A bigger piece would stay put without sticking it, so you could pull it out to put a full height in. |
#3
|
|||
|
|||
*
Thanks Ian
|
#4
|
||||
|
||||
You can cut the posts down, theres still enough thread
|
#5
|
||||
|
||||
I've got some you can have on Sunday Jamie.
__________________
TLR, Screwz4RC, Spektrum, Horizon Hobby, Trinity, Trishbits, Racer, RichPaint, RDT products, Sanwa, Zen Racing, Silverback Lipo's http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
#6
|
||||
|
||||
I use the foam method as above.
If I want to run full size LIPOs then you just swap LH and RH and turn them upside down so the foam sticks up, not down Wingers
__________________
Schumacher KC / KF / K1 Aero / MI4CXL - SRCMCC - Puppy Paint |
#7
|
|||
|
|||
i drilled a 1.5mm hole at the correct height and use bodyclips to secure.
Nathan Ralls
__________________
www.rallsracing.com HPI, Answer Rc, Rc Disco, Pace Design |
#8
|
|||
|
|||
*
Thanks chaps for all your help - much appreciated
|
|
|