|
#1
|
||||
|
||||
2.5mm diff balls in Mad Rat ??
I know they're 3/32" (2.38mm) but would 2.5mm balls fit ? Only i can easily get Schuey carbide ones. I'm aware they would result in the outdrives being 0.24mm wider overall but the diff has plenty more lateral play within the gearbox housing than this anyway, & i'm also unsure whether they will drop into the diff gear ok ?
Any other obvious factors i've forgotten ? Dan.
__________________
TLR 22 3.0/3300kv brushless Lunchbox/Helion 2wd sct/Dromida MT4.18/Orlandoo F-150/Mardave Cobra/Re-re Cat xls w/uprated tranny/Re-re Top Force/Carisma GT24R http://www.norfolkbuggyclub.moonfruit.com/ |
#3
|
||||
|
||||
I know i can get 3/32"'s online but i can get Schuey 2.5mm ones tomorrow from my local shop.
__________________
TLR 22 3.0/3300kv brushless Lunchbox/Helion 2wd sct/Dromida MT4.18/Orlandoo F-150/Mardave Cobra/Re-re Cat xls w/uprated tranny/Re-re Top Force/Carisma GT24R http://www.norfolkbuggyclub.moonfruit.com/ |
#4
|
|||
|
|||
Can you not take a drive cog and try a ball so to speak lol, if it fits in the holes then you're onto a winner
|
#6
|
||||
|
||||
xray ones are a much better fit
http://www.modelcarsreading.com/prod...category_id=74 also the diff plates fit and wear better to |
|
|