New In The TORCH 1/8th Nitro RTR and KIT Truggy

[richardj]

• It´s showtime - when the Torch is coming. Wide - bad and mercilessly are the characters of this truggy in 1:8 scale. The destructive tyres claws in to the ground like a plow. Even jumps are mastered by the torch as if every ramp is his territory.

TORCH Truggy Kit

• • 4WD all-wheel drive
  • Complete ball bearings
  • 17mm aluminium big bore shock absorbers
  • 3 differentials
  • Steel main gear
  • 3mm aluminium chassis plate with side guards
  • 5mm aluminium shock towers
  • CVD drive shafts at the front axle
  
  
  

• 

• 
  
  Large volume 17mm big bore shocks provide maximum durability under all conditions. With multiple adjustments on the shock towers you can adjust your Torch N optimal for each track.
• 

• 
• 
  
  
  Through the relative far forward tank, radio plate and engine position is the weight distribution in front of the truggy. Thereby you can control the Torch N better in jumps.

• 
  
  At the front axle built CVD shafts. The rear drive shafts are protected by mud guards against dirt an stone chips.
• 

• 
  
  For perfect driving performance you need suspension arms which resists all. That is why the Torch N has all the plastic parts from the competition truggy T8T.

• Fully adjustable suspension with right-left hand thread
• Mud guards at the rear axle
• Fibre-reinforced high-quality plastic parts from the T8T
• Adjustable wheelbase
• Aluminium steering rack
• Swaybars at the front and rear axle
• Fuel tank with 150ml capacity
• Pre-printed body
• Length: 590mm
• Width: 430mm
• Heigth: 220mm

Available now through your local hobby store. Visit www.s-m-d.co.uk

Also Available In RTR Form

• 

Torch N 4WD Nitro RTR

Equipment:

• 3.5 ccm race engine "F349" with 1.4 KW / 1.9 HP and 33.000 RPM
• Race exhaust system
• 2.4 GHz 2 channel radio control CR2S
• 3 channel receiver
• 9 Kg steering servo with metal gear S90MH
• 4 Kg throttle/brake servo