|
#1
|
||||
|
||||
501,B44 front arms --> S4 ?
On the S4, can someone tell me how i do it? I have only broke 4 front arms his year, 2 rears...but the week point is the material thicknes near the hingpin(front) .
Any lnk to a mod, or even better, any pics how this will be done? Let me know. |
#2
|
|||
|
|||
ye id like to know also how you fit the tamiya arms to the BJ4 worlds lol
|
#3
|
||||
|
||||
There's a post somewhere where someone detailed how they did it
aha, here it is: http://www.oople.com/forums/showthre...ight=501x+arms |
#5
|
|||
|
|||
cheers jimmy ...
gonna go steel some 501x arms from my dad now haha ! |
#6
|
||||
|
||||
Got some B44 front arms in front of me, and there is very little difference between them and standard S4/BJ4WE arms, there is one little difference which is the lugs were the hinge pin goes through. The gap between them is 13mm on the B44 compared with almost 16mm on a standard arm.
__________________
Jonathan | Atomic-Carbon |
#8
|
||||
|
||||
I would go for the B44 arms as they will be cheaper and easier to find and they are plastic rather than graphite, so will flex a tad before they break, and it is a simple mod to chop down the lug a little, rather than modding the bulkhead.
__________________
Jonathan | Atomic-Carbon |
Thread Tools | |
Display Modes | |
|
|