|
#1
|
|||
|
|||
HPI PRO4/Cyclone D4 parts intercgangability
I have been running aHPI PRO4 and because of this,I have loads of spares in my pit box. What suspension parts,if any,are interchangable with my Cyclone D4?
|
#2
|
|||
|
|||
i don't think much of the suspension is interchangeable, but parts of the drivetrain are such as the crown gears, front one-way etc. Obviously general hardware like screws, ball studs etc will be usuable to.
__________________
4wd - X4TE 2wd - X2C (Mad Rat passed down to son!) Ansmann Racing UK RIP - MicroTech Racing Trader Feedback |
#3
|
||||
|
||||
If you have both cars, you are probably in a better position to answer the question than anyone.
|
#4
|
|||
|
|||
I'm wondering if the bevel gears are the same, they look like they are and have the same amount of teeth.
|
#5
|
|||
|
|||
Quote:
The parts that I was wondering about were the rear hubs,as I have a couple of pairs of alloy ones here. I am off loading the PRO4 and was wondering what bits to keep. Thanks for the input |
#6
|
||||
|
||||
i think most of the gears are the same and the one-way is the same too.
__________________
|
|
|