Go Back   oOple.com Forums > General > International fOrums > USA

Reply
 
Thread Tools Display Modes
  #1  
Old 31-01-2011
Bigmuff Bigmuff is offline
Member
 
Join Date: Jan 2011
Posts: 2
Default slipper clutch on Tamiya Baldre

Hello folks.

I recently got a Tamiya 53930 Super Stock TZ Motor and was intending on putting it in my mostly stock Baldre. However, I don't know if this 23 turn motor counts as a "high power modified" motor that as per the car's directions would require a slipper clutch. So now I'm afraid to install it for fear of nuking the diff.

Anyone know if I'll need the slipper for this motor?

Oh - and sorry if this is the wrong forum. I think my registration is bugged and I'm having a difficult time posting anywhere.
Reply With Quote
  #2  
Old 31-01-2011
DCM's Avatar
DCM DCM is offline
Spends too long on oOple ...
 
Join Date: Oct 2005
Location: Marvelous South Wales!!
Posts: 8,896
Default

I would always recommend installing a slipper on the Baldre, it will make it easier to drive and take any loading off the rear diff. But you should be fine for a while with the TZ motor, just make sure you check for any slip in the rear diff after each run.
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man!
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 12:22 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com