Fusion Exceed Race with Etronix FHSS won't bind

[JezT]

My new Etronix FHSS system will not bind with my old Fusion Exceed Race ESC. The FHSS Etronix is fine with an LRP ESC and my old DSSS Etronix was fine with both this Fusion ESC and the new LRP ESC. So is there an incompatibility issue.

Has anyone else had the same issue? Are there other ESC's that are imcompatible with the FHSS?

[MartinShortCourse]

Hi

What Etronix system have you got? Is it the one with the LCD screen?

Martin

[JezT]

Yep its the FHSS with screen and blue receiver. BTW it happens (or doesn't happen) with 2 blue receivers.

[fidspeed]

can you plug standard servos into both steerring and throttle ports on the RX do they work properley ?

if so the fault is not with the "bind" as the bind process is only linking TX to RX nothing to do with ESC

hope im not coming across too "clever" and it may not help but it will eliminate TX/RX as being faulty .

hope you get somewhere

Fid

[MartinShortCourse]

Hi

Under the throttle stick is the ATL function. This controls how much braking you get. Sadly, when you reverse the channel to use a brushless motor combo, this function now acts on the throttle and not the brake. Make sure the ATL function is on 100% and then try and set up the ESC again. There is a display on the main screen on the transmitter showing the value of the ATL, it defoults to 50% which does not give it enough throttle to set up your Exceed ESC.

Hope this helps

Martin

[JezT]

Martin - You are a star

Yep, that worked a treat.... Cheers