|
#1
|
|||
|
|||
X6 Sq. Shorty lipo front to rear?
Would this fit without cutting away the front cross-chassis rib behind the servo? (I realise I will have to do lots of other cutting!). SuperDan? Ta.
|
#2
|
||||
|
||||
If you mean the rib directly behind the servo, then yes
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER |
#3
|
|||
|
|||
Thanks, am planning on using Vampire shorty, hopefully they are all similar...
|
#4
|
|||
|
|||
That is what most of our team run when they use shorty, Dan Greenwood has run this LIPO (down the middle as you suggest) most of this season....
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
#5
|
||||
|
||||
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER |
#6
|
|||
|
|||
Shorty Lipo will fit
|
#7
|
||||
|
||||
Quote:
You have to cut the bracing in the middle of the chassis that separates where the cells across the back go from the space in the middle I.e. between the old 4 cells and 2 cell space. The vampire lipo is then about 5mm shorter than the space left so you can space it slightly forward or back as required. The rib behind the servo I've kept and use that as the stop for the cells as per the picture in the other thread in the link above.
__________________
Nortech is ACE! |
#8
|
|||
|
|||
Thanks guys. Project rear roll bar next....
|
#9
|
|||
|
|||
May just be able to help you out a little with that one too shortly, stay tuned
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
#10
|
|||
|
|||
Sounds interesting, I am hoping you are going to say you are getting some roll bars in that work with the Losi XXX-4 mounting kit..... Wasn't looking forward to prospect of making my own from piano wire... Can I ask for this for Christmas or will it be post-Crimbo?!
|
Thread Tools | |
Display Modes | |
|
|