|
||
|
 |
|
||||||||||||||||||
|
#1
26-11-2012
|
||||
|
||||
savox 1251 problem
i have a savox 1251mg and it has an annoying problem when you go to fast from left to right it cuts out and resets the receiver? it`s as if it`s draining all the power. have any of you had this issue before and what was it?
__________________
teh-r31 drifters, exo terra 
|
|
#2
26-11-2012
|
||||
|
||||
|
it's drawing too much current. common problem with savox servos.
Use this: http://www.rccarshop.co.uk/index.php...protector.html or make one up with a 4700uF 10v electrolytic capacitor and a servo plug.
__________________
-------------------------------------------------------------------------------------------------------------------
Team Yokomo - YZ-2CAL3 | YZ-2DTM3 | YZ-4SF2 | YZ-2T | YZ-2DTM Worlds | YZ-2DTM x2 | YRX-12 x2 ------------------------------------------------------------------------------------------------------------------- 10electric | Batley Buggy Club | YORCC | RHR | MB Models ---------------------------------------------------------------------------------------------------------------
|
|
#3
27-11-2012
|
||||
|
||||
|
i think i have one of those with my novak esc. will dig it out and try it thanks
__________________
teh-r31 drifters, exo terra
|
|
#4
27-11-2012
|
||||
|
||||
|
Etronix also have a power cap available to do this
http://etronix-rc.com/etronix-receiv...er_name=ET0077 
__________________
 CML Distribution - Distributors of Quality Radio Control Models & RC Hobby Products
|
|
#5
27-11-2012
|
||||
|
||||
|
il also had this issue when i ran that servo with a spektrum radio set.its cheap as chips to make your own power cap but for the price you can get them for now id save your self the hassle and buy 1.
__________________
|
|
#6
27-11-2012
|
||||
|
||||
|
The savox can draw over 2A, check the technical specs here
http://www.savoxusa.com/Savox_SC1251...avsc1251mg.htm I tried it on a Pace 45-R with a power cap, no luck, ended up swapping in an alternative. Some people seem to get them working with a power cap so for the cost of them it's worth a shout.
__________________
Kyosho ZX6 Kyosho FS2 Kyosho RB6 Kyosho DB1 Kyosho DB2 Kyosho Turbo Ultima Kyosho Optima Schumacher Atom NORA - Northern Off-Road Arena - www.ddrcc.co.ukTrader Feedback: http://www.oople.com/forums/showthread.php?t=49044
|
|
#7
27-11-2012
|
|||
|
|||
|
The power cap may fix the problem on the bench, but one good high-speed sweeper on a grippy track and the problem will return. Once the capacitor has emptied its contents if the servo is still drawing power it will cut the receiver.
Best answer is a receiver pack that will deliver what you need all the time. HTH 
|
|
#8
27-11-2012
|
||||
|
||||
|
i run savox 1251`s in all my mardave car and this is the only one with the problem. all the others are perfect!
__________________
teh-r31 drifters, exo terra
|
|
#9
28-11-2012
|
||||
|
||||
|
Have you tried that servo in a different car?
As the servo is the same in all your cars, what are the differences? Logic would imply that the difference is the problem, not the things that are the same.
__________________
|
|
#10
28-11-2012
|
||||
|
||||
|
Following on from cols train of thought
swop the "duff" servo into a car which has no issues if you have issues still it is the servo which is faulty if the issue does nor occur when swapped then it points to the car set up in which it is installed causing the , the problem usual suspect is the esc not being able to suppy rx adequately causing it to switch off and reset as mentioned before its a known savox behaviour regards fid
|
 |
|
|
Linear Mode
