|
#1
|
||||
|
||||
non ansmann 12mm hex wheels
hi
what non-ansmann wheels fit on the standard 12mm hexs of a x2c cheers lee |
#2
|
||||
|
||||
Kyosho fit, i use them on my x2c.
__________________
TLR 22 3.0/3300kv brushless Lunchbox/Helion 2wd sct/Dromida MT4.18/Orlandoo F-150/Mardave Cobra/Re-re Cat xls w/uprated tranny/Re-re Top Force/Carisma GT24R http://www.norfolkbuggyclub.moonfruit.com/ |
#3
|
||||
|
||||
i have used kyosho lazer zx-5 sp wheels on my mad rat and x2 and they are just as good.
|
#4
|
||||
|
||||
again kyosho or hotbodies
__________________
DO NOT BUY/SELL TO THIS USER. |
#5
|
|||
|
|||
I've bought some Yokomo 12mm alloy wheel hexes to try on the front. They look like they will fit??
Will try soon?? Keith |
#6
|
|||
|
|||
Are they narrower? will it fit in the BRCA box?
|
#7
|
|||
|
|||
What thickness are the wheel hexes on an X2c?
keith |
#8
|
||||
|
||||
@toooldskool,
I think you need to some adjusting with the axles if you are planning on not using the B4 axle conversion. I am lead to believe that the XTE alloy hexes will go on with some drilling out and then I think the X2C axles need to be cut back - but I might be wrong. |
#9
|
||||
|
||||
Quote:
Also i have been told a good tip (think it was on here or on the Ansmann UK racers facebook page, fit some 8th clutch shims as spacers if you get problems with binding.
__________________
|
Thread Tools | |
Display Modes | |
|
|