Frankenstein's Madcap

[bigalbi]

I can't afford a complete Astute or even less a Super Astute or DynaStorm and if I owned one of them I don't think I would let it leave the shelf.

So I am going for a sort of hybrid Madcap/Astute/Super Astute that I can run.

The chassis, towers and brace are courtesy of Fibre-Lyte. Most of the other parts are from Fleabay Sourced Madcap bits.

So it begins: -

The start off bits.

DSCN0761.JPG

For some reason the fibre-lyte chassis's back three holes were not countersunk so these were rectified. I also drilled and countersunk 2 new holes for the uprights to support the madcap front top brace.

DSCN0763.JPG

Then I could mount the front bulkhead and the rear suspension hangers and support posts.

DSCN0764.jpg

I had to drill and tap 2 new holes in the underside of the Madcap rear top bulkhead to maintain strength and reduce flex.

DSCN0766.JPG

The front Shock mount was setup for a super astute so I had to remove some material from the top lip and drill 2 holes for the Madcap body post.

DSCN0767.JPG

Gearbox and rear brace assembly was then completed.

DSCN0768.JPG
DSCN0769.JPG

The front shock mount and bracing installed.

DSCN0773.jpg
DSCN0774.jpg

Then corners were hung.

DSCN0772.JPG

That's where I'm at so far more updates to follow.

[Dom9]

Love it! Looking forward to updates!

[Topcat Ron]

Also love it dude....addresses many of the known weak points

[cjm_2008]

That front kickup / bulkhead will snap at the first opportunity.

You'd be better off replacing it with an ORB racing 3d printed part.

Same for the rear inner hingepin hangers (the small blocks that sit either side of the gearbox)

Otherwise, NICE!

[LeonT]

This looks amazing! I have a Madcap and a Super Astute.
If I break the Madcap chassis, I'll go down this route and build an Astute/Madcap hybrid.

[bigalbi]

Thanks all for the kind comments.

Waiting for bits now. Have ordered a DT02 turnbuckle set as these appear to be compatible on length for the top links. Think the ball cups are probably better then the older ones too.. Need to sort the steering, have some top force stuff that might work. Need to check geometry and height. Thinking I need to make some risers if it works out.

[bigalbi]

Originally Posted by cjm_2008

That front kickup / bulkhead will snap at the first opportunity.

You'd be better off replacing it with an ORB racing 3d printed part.

Same for the rear inner hingepin hangers (the small blocks that sit either side of the gearbox)

Otherwise, NICE!

Hi, Thanks for the feedback. Have you had direct experience of these failures. Is the Orb part head and shoulders stronger? I was hoping the bracing top and bottom against a carbon chassis would make this less prone to break.