|
#1
|
|||
|
|||
Wheel bearings CRF
I have just finished building the CRF GT but I'm stuck with the front bearings. I have used the included spacers, but when the wheel nut is tightened fully it tightens up the bearing and locks the wheel. Has anyone used this chassis and if so, is there a specific shim to use on the front.
|
#2
|
|||
|
|||
Just tighten the wheel nut to the point where its sitting against the bearing but the wheel can spin freely. Its a pretty normal thing in all LMP/F1/GT cars.
|
Thread Tools | |
Display Modes | |
|
|