LRP Sphere "clitching" under acceleration

[Steve.T]

I run a sphere which has developed a clich when it accelerates. I have tried resetting it and resyncing my radio gear but this has not helped.
Any advice greatly recieved

[mattr]

Sensor cable.
Sensor board.
Motor wires.
That's what if be looking at in the event of glitching.
Could have a short or fault in any of them

[ralphee]

Had the same problem with a HW 2.1 XErun, no matter what i did id get a glitch under low throttle application.
In the end it turned out to be the servo/esc combination, even with a power cap it had the problem, ended up swapping out so much stuff, i bought a new esc and servo, try swapping out a lower draw servo first though!

lee