|
#1
|
|||
|
|||
SX2 Gearing help needed
After being away from racing (RC in general really) for about 6 or 7 years, I am getting ready to build a new SX2. I have been looking over the build options and going over some set-up sheets, but am still lost on a couple of points.
I will be racing on Indoor Dirt Offroad (large jumps, rollers etc.) track with a Clay or Clay base with some loose dirt covering it, type of surface. Longest Straight is roughly 100 feet or so. Firstly Internal Ratio: I am planning to start with a Brushed motor likely a 10 trun double or 12 turn double. Should I stick with the stock internal ratio, or what internal ratio should I be using? Secondly Pinion Spur Combination: What would be appropriate for a 10 turn double or 12 turn Double brushed motor. Thanks, Trevor |
#2
|
||||
|
||||
go on rctech.net and find Raul Garcia. He can point you in the direction you need on gearing and a good base setup for the cat on a clay track.
|
#3
|
|||
|
|||
Quote:
Thanks, I will try there as well. Trevor |
|
|