|
#1
|
||||
|
||||
INSPIRE4 1/10th 4wd buggy
hello this is a project I'm working on its called the INSPIRE4
+++ INSPIRE4 spec list +++ *Quick diff height adjustment, just loosen 3 screws on the chassis and slide a shim under the gearbox also easy to remove the whole diff case with the same 3 screws without affecting any of the suspension . *Quick diff change without the need to remove the whole diff case or affecting any of the suspension. *Low diffs front and rear. ... *Left-right, front-rear wishbone are the same complainants. *Front and rear bulkheads are the same *The buggy has the lowest CG of any other rc buggy on the market. *Adjustable front kick up and caster. *Adjustable anti-squat plus the option to run pro-squat. *Inboard suspension design with the dampers mounted as low as possible. *Easy adjustable rocker ratio. *Unique to the “INSPIRE4” a cross over quad rocker rear suspension system. *Suspension geometry designed from scratch. *Quick release spur gear. *Chassis layout to achieve a 50/50 weight distribution (depending on electronics). *Adjustable chassis flex *Large angled side pods to increase ground clearance when the chassis rolls through the corners and decrease the chances of chassis rub. *Flat chassis design *No shock towers to disturb the air flow to the wings and body shell. *CFD software used when designing the car. *Minimal weight passed the front and rear axles. *Wings mount perfectly over the centre line of the axles. check out its facebook page https://www.facebook.com/MRO-Racing-757539404314286/ |
Thread Tools | |
Display Modes | |
|
|