|
#21
|
||||
|
||||
Here´another pic to show that the main shafts are slightly offset.
|
#22
|
||||
|
||||
Yes yes I see it now fredrik was correct
A good way to do it I think
__________________
|
#23
|
|||
|
|||
It was pretty obvious that if all 4 gears were meshed then it wasn't going anywhere Other than into a big pile of striped teeth
|
#24
|
||||
|
||||
Quote:
If the spur turned it's bevel gear independently and the othergear on the same plain was free to rotate And they were all meshed Then the bevel driven by the spur would turn each prop bevel in different directions and would have the load halfd buy the other opposite freely rotating bevel idler... Easy... Could have worked in this way!
__________________
|
#25
|
|||
|
|||
Obviously the act of sarcasm is lost in the land of oOple....
|
#26
|
||||
|
||||
Sarcasm lol
It's hard to use on forums lol Cheers
__________________
|
Thread Tools | |
Display Modes | |
|
|