|
#1
|
||||
|
||||
TLR 22 Exotek chassis
Hi all,
any of you have an exotek chassis'd vehile below: TLR 22 2.20 TLR 22T 2.0 TLR 22 SCT 2.0 If so could I ask a favour? Essentially i have a rear end (shaft driven) from one car and i am going to make a chassis that uses the 22 2.0 front end. what i would like if possible is mainly the chassis (See red on image) But also if possible be interested in the blue and orange distance too if its not to much to ask! More interested in the short course/stadium truck but standard buggy would be helpfull too. Already drawn up the exotek front bulkhead Thanks for the help! LLL
__________________
_____________________________________________ Kyosho TF2 Kyosho TF3 Kyosho TF4-R Kyosho Lazer ZX-R Mk2 Kyosho ZXR Kyosho zx Kyosho Lazer 2000 (with zx parts) Atomic CR2 SCT _______________________________________________ Trader Feedback thread |
#2
|
|||
|
|||
I assume you know you can purchase the Exotek nose piece as a spare part anyhow?
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
#3
|
||||
|
||||
Indeed!
This i what i did and thats how i drew it up just reverse engineered it i suppose Hopefully this should give me the shaped needed at the front chassis to allow the front bit to mount correctly.
__________________
_____________________________________________ Kyosho TF2 Kyosho TF3 Kyosho TF4-R Kyosho Lazer ZX-R Mk2 Kyosho ZXR Kyosho zx Kyosho Lazer 2000 (with zx parts) Atomic CR2 SCT _______________________________________________ Trader Feedback thread |
Thread Tools | |
Display Modes | |
|
|