|
#1
|
||||
|
||||
X6 TOOLS
HI again guys !!
Once again confused !! when I purchased my X6 it didn't come with any tools at all !!! After spending £25 on some they were clearly the wrong ones :-(( ... None fitted any of the wheels nuts , or screws / bolts ... Anybody know where or what ones I need as its a bit of a pain .. Thanks Craig |
#2
|
|||
|
|||
You've bought metric ones then ie, 1.5mm, 2mm etc. As the fittings are all American (the Associated RC10 that the X6 uses as its donor is a US product as is the X6 of course) they are imperial ie, 4/40, 8/32, 2/56 etc. You could buy expensive Associated or Losi branded stuff. Dont know if EDS do imperial tools but they have a good write up. On the other hand I have had a set of cheapy Dynamite branded hex drivers and Allen drivers I picked up in 2007 and they are still going strong now. You should be able to get them from any of the usual suspects, DMS, JE Spares etc.
|
#3
|
||||
|
||||
EDS definately do imperial tools
__________________
B-Max 2 MR
KEEP RIGHT ON BLUE IS BETTER |
#4
|
||||
|
||||
I have a Dynamite set and and they are lasting very well,I keep a pin in my toolbox so if you want to undo a screw on the underside put the pin in the head first and give it a wiggle about,this will get any mud/rubbish out and let your driver go in all the way,if you dont the smaller sizes especially will "round off".
__________________
X-Factory X-6 Cubed |
#5
|
||||
|
||||
I'd recommend a cheap Dynamite set plus quality hex drivers for the smaller sizes ( .050” and 1/16”) to avoid stripping small screws.
__________________
|
Thread Tools | |
Display Modes | |
|
|