Stuff!:D

Chris Harte · #1 09-08-2009

Motors £4.50 each.

27turn Co27 PRU motor can with and epic 27 armature that has been marked as RPM as 21675@5.0V, 62W@10.2K of power, 43.9%@13CL of eff and 97.6Nmn's of torque. Recently skimmed, brushes and springs in good condition.

Yokomo Pro stock 13turn motor. Can in excellent condition. Could do with first skim. Lots of life let in brushes and springs.

Trinity copper head P2K motor in good condition. Again fitted with early Epic 27turn amature. Recently skimmed. Could do with some new brushes and possibly springs.

Cells £5.00 per pack.

All these packs are ideal as practice cells. All have been sat round for a while so will need balancing. All but one pack are six cells and straight packs and have all been fitted with corrallys.

GP 3300's
All these cells are marked at 1.185 volts and give 4423mW/h and have the following resistances;
Cell one 2.6mOhms
Cell two 2.6 MOhms
Cell three 2.7 MOhms
Cell four 3.0 MOhms
Cell five 3.0 MOhms
Cell six 2.7 MOhms

EP 4200's in sadlle pack and unmatched. It might well be a dead pack as cell three seems to of leaked or vented.

Other items
Nosram dominator esc fitted with corrally connectors. Comes with blue wire for older KO servos if needed. Switch is missing but the wires have been soldered together so it still works. £25.00

Ansmann Xmove Deluxe 12volt charger with adaptor for charging corrally connectors.
Comes with original box and looks brand new. Seen very little use as this was my backup charger. £30.00

Much more Cell equaliser with carry case. Brand new and barely used. Maximum discharge rate 3 amps. £10.00

Also thrown in will be misc spares, cable and heatshrink if bought with everything else - free

Also for sale is a RC12 L3 that I now have to sell as I need funds to tied me over with finding jobs.
It has the Hara Conversion Kit fit which means that no T bar is required.
Its a rolling chassis with a few scratches as can be expected. Comes with Green tyres on front and greys on rear.
Also comes with yellow shell which is battered but can still be used.

Spares:
Original T-bar chassis (0.75" t bar fitted, minor surface scratches)to convert back to a regular L3
4 replacement T bars 3x 0.75" 1x 0.65"
2 sets of rear tyres (used) Greens and Greys. Minimal chunking loads of life in them
2 sets of new fronts, greens and purple's.
Few springs, bearings and odds and sods.
Original manual, set up sheets and decal sheet!

Shall we say £37.50 posted for this?