|
#1
|
|||
|
|||
U4619-alloy centre track rod--how many washers req?
http://www.racing-cars.com/pp/New_Ca..._KR/U4619.html
Can someone clear up how many washers this needs? Not clear on advert to be honest. It says "it includes the kit washers" The kit only has a 0.5 washer......! Does it still need the 4mm washers ?? Or is it included somewhere else ??? Cheers
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
#2
|
|||
|
|||
I asked this question to Schumacher. Trish told me that the 4mm spacers are not required; the extra height is built into the servo link.
I still used a very thin washer between this part and the radius arms as it was binding up without. HTH |
#3
|
|||
|
|||
If you build it with 4mm in Gareth the rack fouls the servo arm. The ball joint is higher on the new rack allowing the link to run parallel.
__________________
Trader feedback |
#4
|
||||
|
||||
Lifting the plastic rack only alters the arce the servo arm goes through, as has been said its been done on the new machined part by moving the servo link ball
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#5
|
|||
|
|||
Quote:
So no 4mm on the inner. What about on the outer hubs??? Normally 4mm added there also....
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
#6
|
||||
|
||||
I fitted these to both my sv2 models and left the washers in but found that they had an unbelievable amount of slop and lift in the steering linkage, I experimented with different washers and in the end I removed both washers and also the same from the radius arm mounts and all the slop and lift goes away and still allows everything to move freely, the radius arms have a raised side and a flat side and I flipped them so the raised side sat upwards and when all nipped down I had a freely moving steering system with zero slop or free play, others may disagree with this setup but for me it's how it should be, all the slop just allows the front geometry to be messed up when driving
__________________
Schumacher K2 Schumacher KC Hobbywing XR10 Pro V4 - Xerun V10 - Sanwa - Highest HV www.racing-cars.com |
#7
|
|||
|
|||
Removed on mine, so as per kit with the shorter ball studs. You can of course add washers back in to adjust bump in/out if that is your wish.
|
#8
|
||||
|
||||
None on hubs either
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#9
|
|||
|
|||
Can anyone say what hole does what as there's three
|
#10
|
|||
|
|||
The further forward the hole the more aggressive
The further back the the calmer and smoother it feels
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
#11
|
|||
|
|||
Thank you
|
|
|