FTX PHANTOM 12th??

[DNC]

Hi Guys
Could anyone help with a set up for this car. I haven't run the car yet!
The kit came with green tyres all round. I will change to purple front/grey rear. Not sure how to change the front ride height?

[Chequered Flag Racing]

Originally Posted by DNC

Not sure how to change the front ride height?

Remove the 2 screws in each lower arm and insert a spacer that should have come with the car. This will lower the front end. You should aim for no less than 3mm front & rear. £1 coin is a good guide.

spacers will look similar the ones in this pic



another type of front ride height shim



read this http://www.carsrcracing.co.uk/?page_id=65

[greasy mark]

fiber lite also do a set of shims for this

[Chequered Flag Racing]

Originally Posted by greasy mark

fiber lite also do a set of shims for this

I use to get them cut and sell them, they were better than the ones by Fibre-Lyte, although they cut mine. Much easier to use. Action Model Centre now own the pattern I had. I'll see if I can find a picture.

[DNC]

Thats all really useful info thanks
Had my first outing with the FTX this week! Its awesome fun! Think I could get addicted to 12th?? though I did break a wishbone. It now has a complete L4 front end and body posts! The associated parts look my stronger!

[rich67]

Check out associated L4 setups as its virtually the same car but not carbon.

[Chequered Flag Racing]

Originally Posted by DNC

Thats all really useful info thanks
Had my first outing with the FTX this week! Its awesome fun! Think I could get addicted to 12th?? though

you will

Originally Posted by DNC

though I did break a wishbone. It now has a complete L4 front end and body posts! The associated parts look my stronger!

they are stonger and a whole lot better car

read this
http://www.carsrcracing.co.uk/?page_id=65

and read and print this
http://richardchang.com/hobby.php?topic=112setup

[DNC]

any ideas on which brushless system to fit??