|
#1
|
||||
|
||||
22SCT, conversion 22T--->22 Short Course
hi
present you here my actual project i have buy the chassis on RCTech, RCracing Design, very nice quality and perfect fit now, the picture of the begening julien // AKBody Truck chassis move for the SCT sc10's RPM bumper and body mount, with 22 mid motor plate for support tonight the rear parts
__________________
|
#2
|
||||
|
||||
Like it
Clever work with the front body mount. In UK we would have to run rear bumpers so would have to adapt something for back end. Have you sorted the wheel fitment/offset issue yet? Shame RCRD refused to sell one to me in UK... surely it's racism these days! especially when i have a one run 22T gathering dust and no Stadium truck mates to race with over here Guess i'll have to wait for the TLR version...or maybe there is something more special being brewed up for the UK SCT racers |
#3
|
||||
|
||||
nice! mid motor config also works? (would make it better handling )
__________________
Ansmann ARE-2 - 5.5T C4.1 Centro - 7.5T X-Factory SCX-60 - 10.5T Hyper 9e - MMM |
#4
|
||||
|
||||
thx you
i think Mid version is not a problem, just find an other rear bumper system, i have just finish the rear, pictures tomorrow. for the offset issue not real solution, i think i will try rear buggy hex.
__________________
|
#5
|
|||
|
|||
width of stc
the sct width is 296 mm the width of the sc wheel will make the truck 296 mm 330 width of truck -17mm width width difference of short course tire width
the problem i see is alxel stub length being to long i may be wrong but might try 22 axel stubs and hexes too hope that helps |
#6
|
||||
|
||||
i will try will 22 axles and hex for the rear and Traxxas Fr Axles:BA TRA2437 for the front
__________________
|
#7
|
||||
|
||||
rear bumper and bodu post OK
i have cut a rpm rodend for add between shock tower and bumper i have adapt sc10 motor guard with the losi's julien
__________________
|
#8
|
||||
|
||||
Very Nice!!!
|
#9
|
||||
|
||||
__________________
|
Thread Tools | |
Display Modes | |
|
|