|
#1
|
||||
|
||||
B-max2 bodyshell
Anyone know if the B-max2 shell will fit the new b-max2 MR?
Dave
__________________
Team Associated Hobbywing SRT Reedy My feedback http://www.oople.com/forums/showthread.php?t=63097 |
#2
|
||||
|
||||
Not sure, would certainly fit at the front end, but probably be a bit to open at the rear, also not sure if the MR chassis is slightly wider.
Will try my B-MAX2 body when the MR arrives.
__________________
Race Cars: Associated B6 & B6D Vintage race cars: Associated RC10's, RC10T, B2 & T2 Kyosho Ultima XL Losi JRX2, JRX Pro & Pro SE Yokomo YZ10 94 The Veterans Inner Circle. Sponsored with Pot Noodle and Tunnocks. |
#3
|
||||
|
||||
It could certainly be trimmed up at the rear but it was the chassis shape I was wondering about.
I'll just have to wait til mine comes.
__________________
Team Associated Hobbywing SRT Reedy My feedback http://www.oople.com/forums/showthread.php?t=63097 |
#4
|
||||
|
||||
Forgot about this picture
__________________
Race Cars: Associated B6 & B6D Vintage race cars: Associated RC10's, RC10T, B2 & T2 Kyosho Ultima XL Losi JRX2, JRX Pro & Pro SE Yokomo YZ10 94 The Veterans Inner Circle. Sponsored with Pot Noodle and Tunnocks. |
#5
|
||||
|
||||
Ahh, that's the B-max2 shell on the MR. So it should fit.
Thanks
__________________
Team Associated Hobbywing SRT Reedy My feedback http://www.oople.com/forums/showthread.php?t=63097 |
#6
|
|||
|
|||
As the car on the pic was still a prototype, I'm not sure about that.
|
#7
|
||||
|
||||
Just measured the two chassis's and the original B-Max2 is 120.5mm at its widest point and the MR chassis is 130.5mm I'm affraid.
__________________
Race Cars: Associated B6 & B6D Vintage race cars: Associated RC10's, RC10T, B2 & T2 Kyosho Ultima XL Losi JRX2, JRX Pro & Pro SE Yokomo YZ10 94 The Veterans Inner Circle. Sponsored with Pot Noodle and Tunnocks. |
#8
|
||||
|
||||
10mm? Oh that will stretch!!!
Thanks for checking. Dave
__________________
Team Associated Hobbywing SRT Reedy My feedback http://www.oople.com/forums/showthread.php?t=63097 |
|
|