|
#1
|
||||
|
||||
Atomy b44 - servo + receiver mounting
Can anyone recommend posts to use to mount the servo?
Am I correct in assuming most people would put the receiver on its side next to the servo ? |
#2
|
||||
|
||||
Yeh put the receiver on its side. Erm not sure on servo posts. Maybe use losi xx4 mounts?
__________________
Schumacher Racing - Reedy - Schelle - TKR - Bandicoot Bodies - MIP - Nextlevelrc - Trishbits - Moss Models |
#3
|
|||
|
|||
I think the posts that are used are the AE RC10 GT servo mount posts, but they are cut down a little
|
#4
|
||||
|
||||
Quote:
those look like ones for mounting servo horizontally |
#5
|
||||
|
||||
Ive got Losi ones on my S4 and they seem ok. Cant imagine much difference to the Atominized B44 ones..
You can use B4 ones if you were to lay the servo down too, Plus doing this will give you extra room for say mounting the recevier onto
__________________
|
#6
|
|||
|
|||
i use long screws with nuts on, worked a treat all season!
|
#7
|
||||
|
||||
Atomised B44 Servo????
Speaking of servo's, i've just bought an Atomised B44, but i've been told i can only run a low profile servo? is this true? if so, can anyone recommend one?
Does the Associated xp 1015 fit? Cheers Last edited by Pedros20; 10-09-2008 at 02:58 PM. |
#8
|
|||
|
|||
I run the AE XP1015 no problem.
you can run a short servo if you like, but I like the full sized AE ones |
#9
|
||||
|
||||
b44 servo
Cheers Chris.
I'll do the same. |
Thread Tools | |
Display Modes | |
|
|