Go Back   oOple.com Forums > General > 1/10th OFF ROAD

Reply
 
Thread Tools Display Modes
  #1  
Old 1 Week Ago
On the roof On the roof is offline
Member
 
Join Date: Apr 2017
Posts: 125
Default esc issue!!

Just picked up a hobby wing quick run esc for my son brand new calibrated it works fine.. but when the controller is turned off the car hits full acceleration... I canít figure this out must be a easy fix but Iím stuck
__________________
Schumacher KC
Tekno eb410
Reply With Quote
  #2  
Old 1 Week Ago
Origineelreclamebord's Avatar
Origineelreclamebord Origineelreclamebord is online now
Mad Member
 
Join Date: Sep 2010
Location: Netherlands
Posts: 1,536
Default

In 'the old days' (with 27Mhz etc. transmitters) it was standard protocol to turn on the transmitter before the car is on and turn it off after the car is turned off for this very reason, and in case any other signals were transmitted on the frequency nearby.

So this I guess would be the first thing to do. As far as my knowledge goes, most (competition) ESCs are programmed to stay completely idle when the transmitter is turned off first, or even to turn off when the car does not detect its transmitter signal for five seconds.

Maybe it would help to check that all trims are neutral on the transmitter and calibrate the ESC again; otherwise I would contact the manufacturer about it. They should know
__________________


3D Printing Upgrade Parts - FF210 Buggy
Reply With Quote
  #3  
Old 1 Week Ago
Hairy Spider's Avatar
Hairy Spider Hairy Spider is offline
Senior Member
 
Join Date: Mar 2007
Location: Ashford, Kent
Posts: 493
Default

Hi,

You probably just need to rebind your handset to your receiver if you haven't done so since you replaced the ESC. The receiver is most likely going into the failsafe setting when the handset is turned off. rebinding will set the failsafe to neutral.

Regards,
Jon.
__________________
Faversham Off-Road Cake Club
Cake In... Speed Out!
www.forcc.co.uk

Reply With Quote
  #4  
Old 1 Week Ago
Yorkiebar Yorkiebar is offline
Member
 
Join Date: Mar 2018
Posts: 53
Default

Yep, sounds like the failsafe on the RX rather than an ESC issue.

Rebinding some (mine for example) deletes the failsafe setting and doesn't default it to neutral, you have to manually set it after a rebind.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 11:08 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
oOple.com