|
||
|
 |
|
||||||||||||||||||
|
#1
27-12-2010
|
||||
|
||||
Follow the build of my Mi4cx
Hi all for anyone who is interested you can follow the build of my New Mi4cx on my Website ..
Follow the link below to my website , then the link on the left to the build www.car69.me.uk Hopfuly the build will be completed over the Xmas Holiday for its first meeting on the 2nd Jan 2011 HTH anyone that is interested Car69 
|
|
#2
28-12-2010
|
||||
|
||||
The Build is nearly complete don't forget to check back as loads more photos are added all the time
www.car69.me.uk
|
|
#3
28-12-2010
|
||||
|
||||
|
The Standard build has finished and setup complete
New Photos added Next steps will be upgrades so check back soon ............. Car69
|
|
#4
28-12-2010
|
||||
|
||||
|
hi
do you always set your droop with roll bars and shocks attached that will give odd readings and i hope you set ride height both sides of chassis when done like that and have you stuck a rpm camber style camber guage on your wheels to check camber when car is ready to run. i found with the gauges you use the ride height would be different to when the wheels were on and the camber would then be wrong. and a something to take note when setting droop and ride height it is all relevant to what wishbone roll centre you are using for example you could have 5mm ride height with lowest setting on roll centre and 5mm droop but if you had 5mm ride height with roll centre 2mm higher you would need to run 3mm droop but you would also need to make sure the shock preload is simular or none. stu rand
|
 |
|
|
Schumacher
Linear Mode
